1991 Johnson/Evinrude EI Outboards 2.3 thru 8 Service Manual, Page 212Get this manual
Assembly
r:;:;] 1Oil and install new a-ring into new shift rod bushing Assemble the Bushing Installer to the Rod (components of OMC Driveshaft Bearing Remover and Installer, PIN 393092)Place the bushing onto the Bushing and Installer with a-ring down Apply OMC Adhesive sealant to the outside of the bushingUsing mallet, drive the bushing into the gearcase until seated1231 2To install new lower driveshaft bearing, assemble components of OMC Driveshaft Bearing Remover and Installer, PIN 393092 (RodGuide PlatePinand Small Disc with
concave side toward bearing) as shownPlace the lettered side of the bearing toward the small discUsing mallet, drive in the lower bearing until the pin comes in contact with the guide plate
1241 3To install new upper driveshaft bearing, assemble