1991 Johnson/Evinrude EI Outboards 2.3 thru 8 Service Manual, Page 149Get this manual
0.2360.244 (6-6,3 mm)
r:j3l 9Install the crankshaft assembly on cylinder block and rotate bearings so that the locating pins are positioned in notches of the cylinder block
) 10Install upper and lower retainer on cylinder blockr:j3l 11Install
new upper and lower crankshaft seals with the lip of each seal facing the crankcasef141 12Apply OMC Screw Lock to thread of leaf valves screws
l:!.J Install the leaf valve and stopTighten the screws to torque
of 27-35 inIbs(3-4 Nm)f151 13leaf v.a.lve .openingReplace leaf stop if opening is not within speCification14Thoroughly clean and degrease the crankcase mating flange of the cylinder block with OMC Cleaning Solvent and let air dryJ,61 15Apply OMC Locquic Primer to the mating flange of the crankcase and let air dryr:;:;J 16Apply OMC Gel-Seal II sealant to the cylinder block flangeThe application must cover the flange evenly and consistently without being excessiveThe application must not come within V4 in(6 mm) of the bearings