1991 Johnson/Evinrude EI Outboards 2.3 thru 8 Service Manual, Page 109Get this manual
Ignition Component ReplacementCD2UL Ignition System i twist and remove all spark plug leads'" 1To avoid accidental starting of engine while servicing,
f61 2Remove the screws retaining the ignition component that is being replaced
l?J separate the bullet connectors underneath the ignition
3If the charge coil or ignition module is being replaced, module
rv 5Loosenpowerheadplates screwsLift the ignition plate the five ignition from the
[!] 6Remove the plate from bottom of the ignition plate7Remove the leads from the spiral wrap and from the ignition component8Apply OMC Ultra Lock to the threads of the component retaining screwsLoosely install the new ignition component on the ignition plateConnect bullet connectors if necessary
[!] 4Remove the wire clamp from the ignition plate