1991 Johnson/Evinrude EI 60 thru 70 outboards Service Manual, Page 341Get this manual
J 2Oil and install both trim caps on the trim rods, as shown f31 3Re install the manifold in the holding fixture Oil and install
both trim piston and cap assemblies into the manifoldSlide the piston into the sleeve, and then with the end cap flush with the manifold, slide the piston all the way to the bottom of the boreDo not thread the end caps into the manifold at this time
4 Without removing the piston and rod assemblies, slide both
end caps off the rods
5 Adjust the manifold on the holding fixture so the trim cylinders are levelUsing the correct fluidfill both sleeves all the way to the top By filling certain areas of the manifold with fluid during assembly, you will reduce the amount of time necessary to purge the system of air when you are finished