1991 Johnson/Evinrude EI 60 thru 70 outboards Service Manual, Page 331Get this manual
o COA2417
COA2419
f511Be sure the manual release valve is screwed in all the EJ wayRemove the retaining ring using OMC Retaining Ring Pliers, PI 303857Remove the manual release valve
2Inspect the O-ring in the manual release valve for nicks and cutsInspect the rubber tip of the valve for tears or deformation3 Remove the oil level plug from the oil reservoir the O-ring on the reservoir plugReplace the 0-
El ring, If necessary
In] 5Remove the two rigid steel lines connecting the top and
bottom of the tilt cylinder to the manifoldWhen removing the line from the top of the tilt cylinder, you will have to hold the tilt cylinder band nut with one wrench while removing the line connector with another