1991 Johnson/Evinrude EI 60 thru 70 outboards Service Manual, Page 269Get this manual
37 5899 5910 COB5629
OMC Long Life TM CablesInstallation
OMCCable Adapter Kit, PIN must be used to install OMC Long Life cables into the remote control1Remove three cover screws from remote control, and pull two halves apart
13611371 2
Place housing half and cover half on flat surfaceApply OMC Triple-Guard grease to all points shown in figuresBe sure to grease the three cover screws' threaded holesremote control cables with OMC Triple-Guard grease
COB5630
[381 3Lubricate outside of brass sleeves at control end of both 1391 4Place trunnion caps over cable trunnions and slide casing guides over cable sleeves332 inhex wrench, start the set screws into each end of both control end wire clamps
1401 5Using a