1991 Johnson/Evinrude EI 60 thru 70 outboards Service Manual, Page 268Get this manual
3Lubricate cable ends with OMC Triple-Guard grease ra:il "'"
i To install throttle cable, move throttle lever arm from
4Begin cable installation with housing half of control
behind plastic plate to expose hole in lever armDo not remove plastic separator plate from housingIf it is missing, cable pins will fall outPlace eyelet of throttle cable between the halves of the throttle lever arm, in line with holesGrease cable pin and drop cable pin through upper lever arm, through eyelet, and into lower lever arm
32) 5Grease cable trunnion pocket and insert cable trunnion
into trunnion pocket in housing halfr:;:;l 6The throttle lever must be in the idle position before reassemblyMove it forwardtoward the front of the housing half until it contacts the stop
1341 7To install shift cable, grease trunnion pocket in cover half134 "'"
Grease cable pin, place eyelet of shift cable between the shift lever halves, and press cable trunnion into trunnion pocket in cover halfInsert cable pin
center of neutral start cam while making sure neutral lock slide of control handle is engaged in notchControl handle should not be able to move without releasing neutral lock slideIf the neutral lock slide does not engage notch in index plate when neutral switch is centered on neutral camit will be necessary to reposition either the control handle or the index plater:;;']