1991 Johnson/Evinrude EI 60 thru 70 outboards Service Manual, Page 265Get this manual
Assembly
'" Failure to follow assembly instructions closely could result in operator losing control of direction and amount of propeller thrust
Lubricate friction points on mechanical parts with OMC Triple-Guard grease1To reassemble control handle, place control handle knob on control handle and secure with screwTighten screw to torque of 20-30 inIbs(2,3-3,4 Nm) Position trimtilt switch into control handle coverSecure with screw Secure control handle cover to control handle with four screws Apply OMC Triple-Guard grease to slide return springPlace slide return spring onto control handle as shown Compress the slide return spring with neutral lock slide and snap neutral lock slide onto control handleAfter installed, spring tension must be felt when pulling up on neutral lock slide Install plate with two screws to control handleTighten screws to torque of 25-35 inIbs(2,8-3,9 Nm)2Install the key switch, warning horn, and emergency stop switch, if removedApply OMC Black Neoprene Dip to the key switch terminals