1991 Johnson/Evinrude EI 60 thru 70 outboards Service Manual, Page 261Get this manual
Control Cable Identification 1Install the throttle and shift cables in the remote controlRefer to Cable Installation, Page 9-16 19l 2Put the control handle into NEUTRAL positionThe throttle 19l 3As you
l.J cable casing guide must retract and the throttle cable casing guide must begin to extend4As you move the control handle into REVERSE, both casing guides must extend5Identify each control cable for proper installation later
l.J cable casing guide will retract completely and the shift cable casing guide will go to the midpoint of its travelmove the control handle into FORWARD, the shift
i before continuing with installationControl Handle Friction
Control cable identification and function must be correct
The throttle friction knob must be adjusted just tight enough to eliminate unwanted throttle "creep" under normal operating conditionsr,Ql 1Turn the knob clockwise to increase friction and counterclockwise to decrease friction2Make preliminary, light adjustment before operating the engine3Make your final adjustment with the boat and engine operating under normal conditionsTrimTilt Switch 1Temporarily disconnect the control handle trimtilt harness from the trimtilt motor harness2Use an ohmmeter calibrated on appropriate scale or continuity light to test continuityr:t1'l 3Connect meter as shownPress the switch in the UP direction Meter must show continuity Meter must show no continuity when switch is releasedDR2068