1991 Johnson/Evinrude EI 60 thru 70 outboards Service Manual, Page 225Get this manual
8Bend the inside loop of the rewind spring in toward the center of the starter housingEngage the slot of the pulley with the inner loop of the rewind spring and install the pulley in the starter housing9Place the friction plate spring washer and the friction plate on the pulley hubSecure the friction plate and friction plate spring washer with the pulley lockring 10Be sure the starter pawl bushing is installed in the pulleyApply OMC Triple-Guard Grease or Lubriplate 777 to boss of the starter pawlPlace spring washer on the boss of the starter pawlPlace the starter pawl in the pulley11 Position the starter housing spring
in the starter housing