1991 Johnson/Evinrude EI 60 thru 70 outboards Service Manual, Page 193Get this manual
1201 7Puttie straps on braided tube ends and attach stop switch assembly to outer handle1211 8Install the idle adjustment knob into the inner handleTab goes into recess in inner handle1221 9Push the throttle cable pin through the end of the throttle cable1231 10Lubricate end of the pin, guides, rollers, helix grooves and inner handle guide slot with OMC Moly LubePlace the guides over the roller pin and place the pin into slots of the inner handlePlace the rollers on ends of the roller pin11Assemble the helix halves on the handle and slide the grip over the helixBe sure the speed indicator is positioned with the speed range not 1800 outSnap the grip into place24 1
12 Install the warning horn assembly on the outer handle
Installation 1Insert the stop button leads and throttle cable through the lower engine cover grommet