1991 Johnson/Evinrude EI 60 thru 70 outboards Service Manual, Page 181Get this manual
6Lubricate and place the bushings in the swivel bracket221 7Place the swivel bracket in the stern bracketsLubricate and place the thrust washer between the stern brackets and swivel bracket ill swivel bracketsTighten the tilt tube nut to torque of 50-54
ftIbs(68-73 Nm)Then, back off nut torquer:;:;]
I.A 8TTL ModelsInsert the tilt tube through the stern and
to 14 turn after applying
bracket and thrust washer into the swivel bracket centerInstall the steering friction handle guard on the tilt bolt with the lip upPush the tilt bolt through the port side of the swivel bracket, thrust washer and stern bracketInstall the other washer and the nutTorque the nut to 14-16 ftIbs(19-22 Nm)23 10Install the shock absorber upper pin through the swivel bracket and shock absorber rod endInstall the spring clip on the pinr:;;] r:;;l 11 Insert the steering friction washer in the swivel bracketInsert the steering friction bushing in the swivel bracket with the "M" stamp to the front