1991 Johnson/Evinrude EI 60 thru 70 outboards Service Manual, Page 157Get this manual
r:;;l 19Lubricate threaded portion of No.1 rod cap screws with Johnson or Evinrude Outboard Lubricant and install rod cap fN=J
Be sure alignment dot on rod cap matches dot on rod and that both dots fact flywheel
20Using instructions supplied with OMC Alignment Fixture PIN 396749, install the fixture and torque the connecting rod screws in stages to 30-32 ftIbs(40-43 Nm) using OMC Torque Socket PIN 331638
r:::-=J Torquing the screws without OMC Alignment Fixture
PIN 396749, or using an incorrect procedure, could cause permanent damage to the connecting rod and crankshaftTo maintain accurate torque values, keep extension length to minimum21Repeat Steps 19 and 20 for each remaining connecting rodr:Jsl 22Thoroughly clean and degrease crankcase mating flange of the cylinder block with OMC Cleaning Solvent and let air dry23Apply OMC Locquic Primer to the mating flange of the crankcase and let air dryf191 24Apply OMC Gel Seal lito the crankcase mating flange of the cylinder blockThe application must cover the flange evenly and consistently without being excessiveThe application must not come within 14 in(6,4 mm) of labyrinth seals or main bearingsINot