1991 Johnson/Evinrude EI 60 thru 70 outboards Service Manual, Page 154Get this manual
Assembly
r::=J Proceed slowlyMake no forced assemblies unless pressing operation is called forAll internal components must be perfectly clean and lightly coated with Johnson or Evinrude Outboard LubricantINotel Use new gaskets, seals and O-rings during assembly
L!J bearingsInstall the bearings in the wrist pin boreAlign the
bearing in the bore using PIN 336660
Apply OMC Needle Bearing Grease to the 28 wrist pin
OMC Wrist Pin Bearing Tool
f31 2Place the two wrist pin thrust washers on the tool with flat side of the washers facing outf41 3The connecting rod has no specific orientationSupport the piston in OMCPiston Cradle PIN 326573Oil the wrist pin bore and wrist pinf41 4Install the wrist pin through the piston and connecting rod, pushing the tool out through the piston