1991 Johnson/Evinrude EI 60 thru 70 outboards Service Manual, Page 115Get this manual
Terminal Installation 1Connect the plug and receptacle before installing the terminalApply isopropyl alcohol to the plug and receptacleAlign arrows and carefully insert the plug into the receptacle2Apply isopropyl alcohol to the terminal cavity[";l
Use only OMC Insert Tool, PIN 322697, to install terminalsTo avoid injury, securely hold insert tool against shoulder of terminal while inserting terminals
1sl 3termmal
the insert tool against the shoulder of the
terminal into its cavityPush the terminal until the top of the insert tool reaches the connector body, seating the terminal1ol 5Check your workSeparate the connector and look at the terminal you just inserted If it is properly seated, apply isopropyl alcohol to both connector halves and reconnect themIf the terminal did not seat, remove it and repeat the procedure