1991 Johnson/Evinrude EI 60 thru 70 outboards Service Manual, Page 88Get this manual
Inspection
f51 1To test the solenoid windings, calibrate an ohmmeter on low ohms scale and connect between the purplewhite and black leads Meter should indicate 5.5 1.5 ohms2To test solenoid valve and seat: Lightly pressurize inlet fitting with alcohol and syringe With lever in run position, no fluid should enter inlet fitting With lever in prime position, fluid should come out both outlet fittingsCOA1136
3 To inspect or replace internal components, remove the four solenoid cover screws4 When assembling solenoid, back up screws in their holes