1991 Johnson/Evinrude EI 60 thru 70 outboards Service Manual, Page 79Get this manual
Disassembly
All screws addressed in this procedure are No15 Torx
'" The air motor cover is under spring pressureUse caution when removing screws and releasing that pressure
L!J holding the
r;] With No15 Torx screwdriver, remove the Torx screws air motor coverTo control the spring pressure, place pump on your bench with the air motor cover facing upwardHold down on cover while removing screws
Set cover, screws, O-ring, and two springs asider:;] Remove the Torx screws attaching the inlet housing to the
intermediate housing and separate these partsAs you lift the inlet housing, the oil piston will be drawn out of the oil pump[":;l Hold the intermediate housing and air motor piston in one hand, and use the other to unscrew the fuel pistonpull gently with counterclockwise motion