1991 Johnson/Evinrude EI 60 thru 70 outboards Service Manual, Page 72Get this manual
Installation Recommendations
Carefully follow the installation instructions packaged with the VRO oil reservoirIncorrect installation might restrict the oil supply to the engine and cause serious powerhead damagesystem is not used, follow this procedure: Install protective cap, PIN 315391, over the oil inlet fitting to protect the pumpSecure with clamp PIN 322654 Disconnect the wiring harnessSeal engine harness Amphenol connector with cover, PIN 335655
1Determine if the standard oil reservoir has sufficient capacity for the applicationIf it doesn't, consider 3.0 gallon reservoirRefer to Optional Equipment, this Section2Choose reservoir location that allows easy access and is within installation recommendationsThe reservoir has 10 ft(3 m) of oil hose and 16 ft(4,9 m) of wiring harness3The reservoir hose can be extended to maximum of 25 ft(7,6 m) If the installation is extended, the oil hose between the primer bulb and engine must be one continuous section with no fittings or connectionsDo not add on to the existing hoseThe wiring harness can be extended by soldering on additional lengths of 16 gauge wireProtect the connections with shrink tube and electrical tapeObserve original wiring polarityr.jl 4When making connections in the oil supply system, use only the ratchet hose clamps supplied with the systemC02810