1991 Johnson Evinrude EI 60 Loop V Models 150, 175 outboards Service Manual, Page 295Get this manual

1991 Johnson Evinrude EI 60 Loop V Models 150, 175 outboards Service Manual, Page 295

Installation 1Place power trimtilt in position Apply OMC Triple-Guard grease to the lower pin and install the pin i ftIbsturn

2If loosened, tighten the tilt tube nut to torque of 50-54 (68-73 Nm), then loosen starboard nut by Va to 14

3Install external snap rings in lower pin with sharp edge of ring facing out4Extend tilt cylinder rod to match up with holes in swivel bracket

Back to 1991 Johnson Evinrude EI 60 Loop V Models 150, 175 outboards Service Manual