1991 Johnson Evinrude EI 60 Loop V Models 150, 175 outboards Service Manual, Page 260Get this manual
Shift Cable f61 1Extend shift cable and lubricate with OMC Triple-Guard grease2Verify that the remote control fast idle lever is down in the RUN position3Move the remote control handle to NEUTRAL i and neutral lockout index plate orientationRefer to Page
8-94Move the remote control handle to full throttle in FORWARDfJl 5Rotate the propeller shaft and shift the gearcase into FORWARDf81 6Install t.he shift cable on the shift lever pinInstall the flat washer and cotter clip
"'" Before connecting shift cable, verify control handle position
19l 7Remove cable retainerPull firmly on cable casing to remove
8Temporarily install the cable retainer9Shift the remote control to NEUTRAL
backlash and adjust cable trunnion nut to locate in anchor pocket
10Remove the shift cable from the shift lever pin and anchor pocketVerify that the gearcase is in its NEUTRALIf there aren't enough threads on the shift cable to allow the adjustment in Step 7, or if the gearcase detent does not correspond with remote control NEUTRAL in Step 10, refer to Section for shift rod height adjustment