1991 Johnson Evinrude EI 60 Loop V Models 150, 175 outboards Service Manual, Page 257Get this manual
t 1431 _.co:::::
1431 7Push core wire CD (from engine end) through wire clamp Q) until wire is flush, 132 in(0,8 mm), with end of casing
1441 8Turn in set screw on large end of wire clamp until ittouches
core wire, then tighten one more full turn to kink and position core wire45 9Grease trunnion pocket in housing halflift throttle cable and rotate cable forward until trunnion cap can be inserted into trunnion pocket
COB5635
1461 10Position throttle lever by hand to align rear hex screw
with access hole in controlInsert hex wrench through hole and tighten second set screw
1471 11 The throttle lever must be in the idle position before
reassemblyMove the throttle lever forward, toward the front of housing half, until it contacts the stop CDPlace casing guide of shift cable between halves of shift lever and shift cable trunnion cap in its pocketGrease outside surface of wire clampInsert clamp through shift lever and casing guide