1991 Johnson Evinrude EI 60 Loop V Models 150, 175 outboards Service Manual, Page 256Get this manual

1991 Johnson Evinrude EI 60 Loop V Models 150, 175 outboards Service Manual, Page 256

COB5629
OMC Long Life TM CablesInstallation
OMCCable Adapter Kit, PIN 173600, must be used to install OMC Long Life cables into the remote control1Remove three cover screws from remote control, and pull two halves apartr:ryl 2Place housing half and cover half on flat surfaceApply OMC Triple-Guard grease to all points shown in figuresBe sure to grease the three cover screws' threaded holes

COB5630

1381 3Lubricate outside of brass sleeves at control end of both
remote control cables with OMC Triple-Guard grease
1391 4Place trunnion caps over cable trunnions and slide
casing guides over cable sleeves
1401 5Using a

332 inhex wrench, start the set screws into each end of both control end wire clamps

Back to 1991 Johnson Evinrude EI 60 Loop V Models 150, 175 outboards Service Manual