1991 Johnson Evinrude EI 60 Loop V Models 150, 175 outboards Service Manual, Page 255Get this manual
3Lubricate cable ends with OMC Triple-Guard grease f31l "'"
i To install throttle cable, move throttle lever arm from
4Begin cable installation with housing half of control
behind plastic plate to expose hole in lever armDo not remove plastic separator plate from housingIf it is missing, cable pins will fall outPlace eyelet of throttle cable between the halves of the throttle lever arm, in line with holesGrease cable pin CD and drop cable pin through upper lever arm, through eyelet, and into lower lever arm
1321 5Grease cable trunnion pocket and insert cable trunnion into trunnion pocket in housing halfr:;:;J 6The throttle lever must be in the idle position before reassemblyMove it forward, toward the front of the housing half until it contacts the stop
1341 7To install shift cable, grease trunnion pocket in cover halfGrease cable pin, place eyelet of shift cable between the shift lever halves, and press cable trunnion into trunnion pocket in cover halfInsert cable pin 1341 "'" 8Shift lever must be in NEUTRAL before reassembly of remote controlPosition neutral start switch on center of neutral start cam while making sure neutral lock slide (R) of control handle is engaged in notchControl handle shoulcT not be able to move without releasing neutral lock slideIf the neutral lock slide does not engage notch in index plate when neutral switch is centered on neutral cam, it will be necessary to reposition either the control handle or the index plater:;;;l