1991 Johnson Evinrude EI 60 Loop V Models 150, 175 outboards Service Manual, Page 248Get this manual
Control Cable Identification 1Install the throttle and shift cables in the remote controlRefer to Cable Insta"ation, Page 8-161:0)
19l 2Put the control handle into NEUTRAL positionThe throttle
19l As you
cable casing guide will retract completely and the shift cable casing guide will go to the midpoint of its travelmove the control handle into FORWARD, the shift cable casing guide must retract and the throttle cable casing guide must begin to extend4As you move the control handle into REVERSE, both casing guides must extend5Identify each control cable for proper installation later
i before continuing with installationControl Handle Friction
Control cable identification and function must be correct
The throttle friction knob must be adjusted just tight enough to eliminate unwanted throttle "creep" under normal operating conditionsf'1Ol 1Turn the knob clockwise to increase friction and counterclockwise to decrease friction2Make preliminary, light adjustment before operating the engine3Make your final adjustment with the boat and engine operating under normal conditionsTrimTilt Switch 1Temporarily disconnect the control handle trimtilt harness from the trimtilt motor harness2Use an ohmmeter calibrated on appropriate scale or continuity light to test continuity