1991 Johnson Evinrude EI 60 Loop V Models 150, 175 outboards Service Manual, Page 204Get this manual
r:;:;l 17Press shift detent down to engage REVERSE (lowest) positionDoing so will provide clearance to install the clutch shaft assembly
1141 18Note the position of the locating pin at the front of the
housingThe pin must engage corresponding recess inside the nose of the gearcase
1,5l 19Tip the rear of gearcase slightly downwardThis will help hold the housing, washer, bearing, and gear well as keep the shift detent depressedInstall the clutch shaft assemblyMake sure the locating pin is properly engaged after the assembly is installed
L!!J Triple-Guard greaseInstall the a-ring into the shift rod cover
r;J 20Lubricate new shift rod cover a-ring with OMC
r:t7l 21Place the shift rod grommet and spacer on the shift rodGrease the threaded end of the shift rod and insert it through the cover bushing Turn the shift rod while pushing it through the bushing to avoid damaging the a-ring