1991 Johnson Evinrude EI 60 Loop V Models 150, 175 outboards Service Manual, Page 199Get this manual

1991 Johnson Evinrude EI 60 Loop V Models 150, 175 outboards Service Manual, Page 199

0.110 in(2,8 mm)DR3184
Driveshaft Shimming Using Tool, PIN 393185
The driveshaft pinion is precisely meshed with the forward and reverse gears by using one or more shims between the driveshaft bearing housing and the thrust washerWhen installing new thrust bearing or washer, bearing housing, pinion, or driveshaft, it is necessary to properly shim the assembly to restore factory clearanceGauge bars are precision made and should be handled carefullyThe length of each bar is stamped near the part numberThis dimension is 0.020 in(0,508 mm) shorter than the actual shimmed length of the driveshaftNote Degrease pinion and driveshaft tapers prior to assembly
19l 1Assemble the driveshaft bearing housingthrust washer

Back to 1991 Johnson Evinrude EI 60 Loop V Models 150, 175 outboards Service Manual