1991 Johnson Evinrude EI 60 Loop V Models 150, 175 outboards Service Manual, Page 198Get this manual
Driveshaft Bearing Housing Service The driveshaft bearing is not serviceableReplace the bearing housing if the bearing is worn or damagedAlso, inspect the driveshaft bearing surface if the bearing is damaged 111 1
Remove the two driveshaft bearing housing seals using OMC Puller Bridge PIN 432127 and OMC Large Puller Jaws PIN 432129Discard the seals
2Remove the a-ring from the bearing housing and discard3Clean the bearing housing in solvent to remove sealer from the seal bore and the a-ring groove
f21 f31 4
Install new seals back to back in the bearing housing using OMC Seal Installer PIN 330268Apply OMC Gasket Sealing Compound to the metal casings of the seals before installingInstall the inner seal with flush lip facing toward the bearing housing, then the outer seal with extended lip facing away from the bearing housingApply OMC Triple-Guard grease to the seal lips after installing5Lightly apply OMC Triple-Guard grease to new a-ringInstall the a-ring in top groove of the bearing housing