1991 Johnson Evinrude EI 60 Loop V Models 150, 175 outboards Service Manual, Page 190Get this manual
Installation r.jl 1Place new O-ring on the driveshaftCoat the driveshaft splines with OMC Moly LubeDo not coat top surface of the driveshaft as lubricant here may prevent seating of the driveshaft in the crankshaft r:;J 2Apply Scotch Grip Rubber Adhesive 1300 to the lower exhaust housing seals' inner surfacesPosition two new seals on the housingApply OMC Triple-Guard grease to the seals' outer surfaces and position the housing on the gearcase3Rotate the propeller shaft and shift the gearcase to FORWARD4Slide the gearcase into place, making sure the driveshaft engages the crankshaft, the water tube enters the water pump, and the lower inner exhaust housing does not slip out of positionr::;'] r;] 5Apply OMC Gasket Sealing Compound to threads of the