1991 Johnson Evinrude EI 60 Loop V Models 150, 175 outboards Service Manual, Page 187Get this manual
r:J6l 20Apply OMC Gasket Sealing Compound to the threads of the shift rod cover screwsInstall the screwsTighten the screws to torque of 60-84 inIbs(7-9 Nm)
21Position the driveshaft thrust bearingthrust washerand shim(s) (selected earlier) on the driveshaftIn
bearingwasherand shim(s) exactly the order shown
1181 22Apply light coat of OMC Gasket Sealing Compound to the gearcase area that contacts mounting flange of the bearing housingDo not coat inside bearing housing bore surface of the gearcasef'19l 23Using OMC Driveshaft Seal Protector PIN 318674, slide the driveshaft bearing housing onto the driveshaft24Pull up on the shift rod to engage FORWARD gearTurn the gearcase upside down by rotating the holding fixtureBe sure any excess grease is removed from the pinion needle bearingsDegrease inside taper of the pinionPosition the pinion in the gearcase2SDegrease the driveshaft taper and install the driveshaft