1991 Johnson Evinrude EI 60 Loop V Models 150, 175 outboards Service Manual, Page 185Get this manual
1Jl7Lightly coat the detent ball and spring with OMC Needle Bearing Assembly GreaseFirst, insert the spring in the housing, then the ball
i arm toward either side of the housingDepress the ball
8Wear safety glasses to avoid injuryFace the detent
and spring with punch while pushing the detent into the housingOnce the detent is past the ball, rotate the lever toward the rear of the housing, then move the detent to engage NEUTRAL position!sl9Thoroughly grease the original 25 needles with OMC Needle EJ Bearing Assembly Grease and place in the bearing casef6110Face the narrow arms ofthe shifter Q) toward the housing, then reach inside and attach it to the detent neckAlign the pivot holes and insert the retaining pin rJl11Push the detent down to its most depressed positionRest the cradle CD on the shift shaft 19, then attach the cradle and shaft to the wide arms of the shifterPull the detent back up to NEUTRAL position to hold the cradle and shaft in place1ol12Coat thrust bearing and thrust washer with OMC Needle Bearing Assembly GreasePlace the bearing on the back of the forward gearSet the washer on top of the thrust bearing4521