1991 Johnson Evinrude EI 60 Loop V Models 150, 175 outboards Service Manual, Page 176Get this manual
Disassembly
1Remove the propeller and mounting hardwareInspect the propeller for spun hub
rv drain the lube from theplugthen the container.plugand 2Remove the oil level drainlfill gearcase into Inspect the
lube and the magnets on the plugs for metal chipsThe presence of small metal chips can indicate normal wear of the gears, bearings, or shafts within the gearcaseLarge metal chips can indicate extensive internal damageMake note for future reference while inspecting internal componentsInspect the drained lubricant for water or burned odorWater in the lubricant will give it milky appearanceOverheating will give the lubricant black color and burned odor3Remove the two screws and retainers holding the propeller shaft bearing housing4Remove the propeller shaft bearing housing from the gearcase using the following: Puller body, pressing screw, and handle from OMC Universal Puller Kit, PIN 378103 Two 5A6-18 11 in(279 mm) threaded rods, two large 5A6 inI.Dflat washers, and two 5A6-18 nuts (obtain locally)Assemble components and pull the bearing housing from the gearcase