1991 Johnson Evinrude EI 60 Loop V Models 150, 175 outboards Service Manual, Page 171Get this manual
f61 5up the water tube grommet with the inside taper
06Install the impeller housing cover rJl 7Apply OMC Adhesive sealant to flat side of the impeller
housing grommet
Install the
grommet, flat side down
8Lightly coat the liner with oilWith counterclockwise rotation, install the impeller into the liner with slot for impeller cam facing out9Run thin bead of OMC Adhesive sealant in the seal groove, and install the special shaped O-ring seal CDInstallation
1Apply OMC Gasket Sealing Compound to both sides of new impeller plate gasket Install the gasket and impeller plate
19l 2Apply OMC Needle Bearing Assembly Grease to flat area of
the driveshaftInstall the drive camThe sharp edge Q) of the cam is the leading edge during driveshaft rotation