1991 Johnson Evinrude EI 60 Loop V Models 150, 175 outboards Service Manual, Page 99Get this manual

1991 Johnson Evinrude EI 60 Loop V Models 150, 175 outboards Service Manual, Page 99

Installation
INot Remove any varnish from both sides of the stator retaining

e screw holesThe stator must have metal to metal contact with the cylinder block and its retaining screwsf71 1Guide the connector wires through the hole in the cylinder block, align the stator roll pin with the hole in the cylinder block, and seat the stator0 2Seat grommet in hole in cylinder blockRemove old adhesive from threads of the stator screwsPrime with OMC Locquic Primer and let dryApply OMC Nut Lock to threadsInstall the screws and tighten to 120-144 inIbs(14-16 Nm)

Back to 1991 Johnson Evinrude EI 60 Loop V Models 150, 175 outboards Service Manual