1991 Johnson Evinrude EI 60 Loop V Models 150, 175 outboards Service Manual, Page 95Get this manual
[!] 7Remove the screws securing the spark lever retainerr:;] 8Pull the spark lever assembly off the throttle camshaftSwing the spark lever assembly away from the flywheel cover [!] 9Remove the flywheel coverDiscard the gasket19l 10Using Snap-on A-144 fixture, or equivalent, remove the flywheel retaining screwsDiscard the screws11Using the two 3s-24x1 inscrews from OMC Flywheel Service Kit PIN 434649, secure the tool to the flywheelTwo of the holes in the flywheel are tapped for the toolTurn the center screw and draw the flywheel off the crankshaftTo avoid damaging the flywheel magnets, OMC Flywheel Service Kit PIN 434649 should be your only method of removing and installing the flywheelInstallation r:j'1l 1Remove any debris from the flywheel magnetsUsing OMC Flywheel Service Kit PIN 434649, lower the flywheel into position on the crankshaft, aligning the crankshaft roll pin with its hole in the flywheelRemove the tool from the flywheel12 2Install new flywheel retaining screws and tighten to 24-29 ftIbs(33-39 Nm) following torque sequence3Apply OMC Gasket Sealing Compound to new flywheel cover gasketPlace new flywheel cover gasket in position on the powerhead)(