1991 Johnson Evinrude EI 60 Loop V Models 150, 175 outboards Service Manual, Page 79Get this manual
[!!] 7Install the carburetor body to float cover gasketr::;:;] BClip float valve to floatInstall float assemblyTighten hinge pin retaining screw securelyInstall gasket to carburetor body
133 9Adjust float height with chamber invertedFloat must be level with gasket surface V32 in(O,B mm)If adjustment is requireddo not put pressure on float valve and seat10Install high speed fuel orifice with OMC Driver PI 317002 and install float chamber plugTorque plug to 30-35 inIbs(3-4 Nm) 134 11Install float cover and retaining screwsBack up screws in their holes to engage original threadsTorque screws in sequence to 1B-24 inIbs(2-3 Nm)135 12Install new O-ring seal and attach main body to throttle bodyTorque mounting screws to 45-55 inIbs(5-6 Nm)When positioning main body, be careful not to roll O-ring seal out of position Installation