1991 Johnson Evinrude EI 60 Loop V Models 150, 175 outboards Service Manual, Page 61Get this manual
Disassembly All screws addressed in this procedure are No15 Torx i when removing screws and releasing that pressure
'" The air motor cover is under spring pressureUse caution
f11 With
a No15 Torx screwdriver, remove the Torx screws holding the air motor coverTo control the spring pressure, place pump on your bench with the air motor cover facing upwardHold down on cover while removing screwsSet cover, screws, O-ring, and two springs asideL-;J_ _
r:;J Remove the Torx screws attaching the inlet housing to the intermediate housing and separate these partsAs you lift the inlet housing, the oil piston will be drawn out of the oil pump