1991 Johnson Evinrude EI 60 Loop V Models 150, 175 outboards Service Manual, Page 35Get this manual
Synchronization and Linkage Adjustments It is important that this step-by-step procedure be followed in sequence and be performed exactly as written to ensure consistent engine idling and smooth operation throughout the RPM range
IN=' Remove the throttle cable from the throttle control arm and
Timing Pointer
the cable trunnion pocket before beginning this procedure
i spark plug leadsRemove the spark plugs
1Prevent accidental starting of the engine; disconnect the
1.jl 2Remove the three screws retaining the timing wheel coverRemove the cover'2l 3Center the timing pointerUsing wrench or socket, rotate the crankshaft in clockwise direction until the cast-in TOC mark on the timing wheel is approximately in (25,4 mm) past the timing pointer
INotel Rotate the crankshaft in clockwise direction onlyrJl 4Install OMC Piston Stop PIN 384887 in No.1 spark plug hole and turn in center portion until it contacts the No.1 pistonLock the tool in place with its ring