1990 Johnson Evinrude "ES" Cross V 88 thru 115, 150 thru 175, P/N 507874, Page 316Get this manual
Push core wire CD (from engine end) through wire clamp Q) until wire is flush '32 in(0,8 mm) with end of casing guide set screw in on large end of wire clamp until it touches core wire, then tighten exactly one more turn This kinks and locates core wirerotate cable forward until trunnion cap can be inserted into trunnion pocket of control
1441 Turn
CJ,C085635
451 Grease trunnion pocket of controlLift throttle cable and
1 Position throttle lever by hand to align rear hex screw with
access hole in controlInsert hex wrench through hole and tighten second set screw
throttle lever arm must be in the idle position before reassemblyMove the throttle lever arm forward toward the front of housing half until it contacts the stop CD 9Grease trunnion pocket in cover halfPlace casing guide of shift cable between halves of shift lever and shift cable trunnion cap in pocket of housingGrease outside diameter of wire clampInsert clamp through shift lever and casing guide