1990 Johnson Evinrude "ES" Cross V 88 thru 115, 150 thru 175, P/N 507874, Page 315Get this manual
"1: 5899 5910 COB562S
OM Long Life ,"' CablesInstallation R
OMC Cable Adapter Kit, PI must be used to install OMC Long Life cables into the remote control1Remove three cover screws from remote control and pull two halves apart
2Place housing half and cover half on flat surfaceApply OMC Triple-Guard grease to all points shown in figuresBe sure to grease the three cover screw threaded holes
13611371
COB5630
1381 313914
Lubricate outside of brass sleeves at control end of both remote control cables with OMC Triple-Guard grease
Place trunnion caps over cable trunnion and slide casing guides over cable sleevesUsing inhex wrench, start the set screws into each end of both control end wire clamps
Move throttle lever arm from behind separator plate to expose hole in lever armIt is not necessary to remove separator plate to install control cablePlace casing guide between halves of throttle lever arm and position guide as shownGrease outside diameter of wire clamp and insert clamp through throttle lever arm and cable casing guide