1990 Johnson Evinrude "ES" Cross V 88 thru 115, 150 thru 175, P/N 507874, Page 255Get this manual
COA3558
Pull up on the drives haft to remove it from the gearcasedriveshaft to pinion taper is locking taperIf necessary, use OMC Puller PIN 390706 and OMC Backing Plate PIN 325867 CD to break the lockInstall the tools as shown by clamping them around the driveshaft with the tool's set screw aligned with the water pump drive cam slotThen, tighten the set screw into the slotAlternately tighten the two vertical screws against the backing plate inserted between the puller and the gearcase until the drives haft pops loose from the pinion, then remove the tools
f61 f71 8
The bearing housing Q), shimsthrust bearing thrust washers will come out with the driveshaft
19l 10Reach inside the gearcase and take out the pinion, nut, and
any loose needle bearings that may have fallen into the gearcase