1990 Johnson Evinrude "ES" Cross V 88 thru 115, 150 thru 175, P/N 507874, Page 248Get this manual
f161 f17l 22Lightly apply OMC Gasket SealinfJCompound to the
gearcase area that contacts mountmg flange of the bearing housingDo not coat inside bearing hou'sing bore surface of the gearcaseUsing OMC Driveshaft Seal Protector PIN 318674, slide the driveshaft bearing housing onto the driveshaft23Degrease the pinion tapersPull up on the shift rod to engage FORWARD gear positionTurn the gearcase upside down by rotating the holding fixturePosition the pinion in the gearcase24Degrease the driveshaft taper and install the driveshaft25Lightly coat the threads of the pinion nut with outboard lubricant and install on the driveshaftTurn the driveshaft by hand to engage the nut
'18l 26Turn the gearcase right side upUsing OMC Driveshaft Socket PIN 311875 and OMC Pinion Nut Holder PIN 334455, torque the pinion nut to 100-110 ftIbs(136-149 Nm)Overtorquing or undertorquing the pinion nut will reduce pinion lifeDo not re-use damaged pinion nuts'19l 27Position the washers on the driveshaft bearing housing screwsApply OMC Gasket Sealing Compound to the threads of the screwsInstall the screws and tighten little at time to press the bearing housing down evenlyTighten the screws to torque of 168-192 inIbs(19-22 Nm)1201 28Oil, then install the thrust bearing and thrust washer on the hub of the reverse gearSlide the reverse gear onto the propeller shaft until it engages the pinionr:;-:;l 29Carefully apply OMC Gasket Sealing Compound to both O-ring flanges of the bearing housing Do not allow sealer to contact either forward thrust surface or bearings in the housingInstall the housing in the gearcase with screw holes in vertical position and anode facing downTap the housing with soft face mallet to seat the O-rings