1990 Johnson Evinrude "ES" Cross V 88 thru 115, 150 thru 175, P/N 507874, Page 245Get this manual
9Subtract the average clearance measurement obtained in Step from 0.030 in(0,762 mm) to determine the correct shim thickness requiredSelect the fewest number of shims to achieve the correct thickness10Remove the driveshaft from the tool baseRemove the collar and bearing housing from the driveshaft and add the required amount of shims INote Use extreme care when removing bearing housing to avoid
damaging the sealsUse OMC Oriveshaft Seal Protector PI 318674
11 Check shimming by reassembling the driveshaft with shims and placing it back into the tool baseYour reading between the gauge and pinion should be 0.030 in (0,762 mm)
112Degrease tapers of the pinion and driveshaft prior to
assemblyAssembly
'N=J Before beginning assembly procedures, all gearcase compo-
nents must be thoroughly cleaned and in serviceable conditionRefer to Cleaning and Inspection, Page 6-8
COA3081
Assemble as shown the following components of OMC Bearing Remover and Installer PIN 391257: