1990 Johnson Evinrude "ES" Cross V 88 thru 115, 150 thru 175, P/N 507874, Page 241Get this manual
6Install two new seals back to back in the rear of the bearing housing using OMC Seal Installer PIN 326690 f5l f6l Apply OMC Gasket Sealing Compound to the metal casing
of the seals before installingInstall the inner seal with lip facing toward the bearing housing and install the outer seal CD with lip facing away from the bearing housingApply OMC Triple-Guard grease to the seal lips after installinghousing O-ringsInstall the O-rings and set the bearing housing retainers and screws aside
f71 7Lig htly apply OMC Triple-Guard grease to th ree new bea ri ng
Driveshaft Bearing Housing Assembly Service
1!51 -DR2061'
The driveshaft bearing is not serviceableReplace the bearing housing if the bearing is worn or damagedAlso, inspect the driveshaft bearing surface if bearing is damaged
Remove and discard the two driveshaft bearing housing seals using OMC Puller Bridge PIN 432127 and OMC Large Puller Jaws PIN 432129