1990 Johnson Evinrude "ES" Cross V 88 thru 115, 150 thru 175, P/N 507874, Page 236Get this manual
Disassembly 1Remove the propeller and mounting hardwareInspect the propeller for spun hubr:;] 2Drain thegearcase by first removing the oil level plugthe oil filiidrain plug You will find magnet attached to one of the plugsInspect this magnet for the presence of metal chipsIf you do find chips on the magnet, they must be steel and must have come from one of the gears, bearings, or shafts within the gearcase, so make note for future reference while inspecting the internal componentsThe plug with the magnet must be installed in its original positionAlso, inspect the lubricant for water or burned odorWater in the lubricant will give it milky appearanceOverheating will give the lubricant black color and burned odorf811gl 3The propeller shaft bearing housing is retained in the gearcase by two screws, two washers, and two retainersThe retainers are behind the outer rim ofthe housingRemove the two screws and the retainersgearcaseUse two OMC Propeller Shaft Bearing Housing Pullers PIN 330278 and the flywheel puller from OMC Universal Puller PIN 378103Assemble the components as shown and pull the housing from the gearcaseDiscard the three O-rings from the housing f101 r:;1l 4Remove the propeller shaft bearing housing from the