1990 Johnson Evinrude "ES" Cross V 88 thru 115, 150 thru 175, P/N 507874, Page 232Get this manual

1990 Johnson Evinrude "ES" Cross V 88 thru 115, 150 thru 175, P/N 507874, Page 232

COA3129
COA3147

Installation 1Place new O-ring on the driveshaftCoat the driveshaft splines with OMC Moly LubeDo not coat top surface of the driveshaft as lubricant here may prevent seating of the driveshaft in the crankshaft'2l 2Apply Scotch Grip Rubber Adhesive 1300 to the lower exhaust housing seal inner surfacesPosition two new seals on the housingApply OMC Triple-Guard grease to the seal outer surfaces and position the housing on the gearcase3Slide the gearcase into place making sure the driveshaft engages the crankshaft, the water tube enters the water pump, and the lower inner exhaust housing does not slip out of positionf3l+'sl 4Apply OMC Gasket Sealing Compound to threads of the gearcase retaining screwsInstall the screws and tighten to the following torques :

Back to 1990 Johnson Evinrude "ES" Cross V 88 thru 115, 150 thru 175, P/N 507874