1990 Johnson Evinrude "ES" Cross V 88 thru 115, 150 thru 175, P/N 507874, Page 223Get this manual
COA3559
7Install two new seals back to back in the rear of the bearing housing V4 modelsuse OMC Seal Installer PIN 326551 V6 modelsuse OMC Seal Installer PIN 3266901sl 8Apply OMC Gasket Sealing Compound to the metal casing of the seals before installingInstall the inner seal with lip facing toward the bearing housing and install the outer seal with lip facing away from the bearing housingApply OMC Triple-Guard grease to the seal lips after installing
L!J housing O-ringInstall the O-ring in groove of the housingInstall new seals on the retaining screwsDriveshaft Bearing Housing Service
f]l 9Lightly apply OMC Triple-Guard grease to new bearing
The driveshaft bearing is not serviceableReplace the bearing housing if the bearing is worn or damagedAlso, inspect the driveshaft bearing surface if bearing is damaged'sl 1Remove and discard the two driveshaft bearing housing seals using OMC Puller Bridge PIN 432127 and OMC Large Puller Jaws PIN 4321292Remove and discard the O-ring from the bearing housing3Clean the bearing housing in solvent to remove sealer from the seal bore and the O-ring groove1sl 4Install new seals back to back in the bearing housing using OMC Seal Installer PIN 330268Apply OMC Gasket Sealing Compound to the metal casing of the seals before installingInstall the inner seal with lip facing toward the bearing housing and the outer seal with lip facing away from the bearing housingApply OMC Triple-Guard grease to the seal lips after installing