1990 Johnson Evinrude "ES" Cross V 88 thru 115, 150 thru 175, P/N 507874, Page 211Get this manual

1990 Johnson Evinrude "ES" Cross V 88 thru 115, 150 thru 175, P/N 507874, Page 211

Propeller InstallationV4 twist and remove all spark plug leads 1'-

1To avoid accidental starting of engine while servicing,

2Coat the propeller shaft splines sparingly with OMC Tripe-Guard grease
L!J assembly onto the propeller shaft
f11 3Place the thrust bushing

in the propeller and then slide the

Install the thrust washer on splines of the propeller shaft
to torque of or continue to tighten to align next cotter pin holeThe propeller shaft should turn freely (engine in NEUTRAL) after the propeller is installed
L!J 120 inIbs(14 Nm)Install new cotter pin

f11 5Install and tighten the propeller nut

Install new cotter pinbending ends over the nut

Back to 1990 Johnson Evinrude "ES" Cross V 88 thru 115, 150 thru 175, P/N 507874