1990 Johnson Evinrude "ES" Cross V 88 thru 115, 150 thru 175, P/N 507874, Page 121Get this manual
OUTPUT TESTSV6 AMP ill plugs installed and torqued in the cylinder headIf necesI.A All cranking output tests must be performed with spark
sary to remove the spark plugs, be sure to keep the spark tester away from open spark plug holesThe following series of steps will systematically isolate problem area in the ignition systemTo reduce your troubleshooting time and to avoid incomplete results, perform these steps in the order written
STEPTOTAL OUTPUT TEST
[!] 1Twist and remove the spark plug leads from all spark plugsf21 2Adjust the gap on the spark tester to
716 in(11 mm)Connect tester leads to the spark plug leadsSecure tester clip to clean engine ground
To prevent possible arcing of high voltage, route tester leads at least in(51 mm) from any metal surface
'" To avoid possible shock hazard, do not handle ignition coils or spark tester during cranking tests