1990 Johnson Evinrude "ES" Cross V 88 thru 115, 150 thru 175, P/N 507874, Page 37Get this manual
Submerged Engines Engine Dropped Overboard (Not Running) If engine is recovered from water immediately, it must be serviced within three hoursSee Prolonged SubmersionIf engine cannot be started or serviced immediately, it should be resubmerged in fresh water to avoid exposure to the atmosphereMake arrangements to have it serviced with the least possible delayOnce the outboard is exposed to air, both fresh and salt water will start etching the highly polished bearing surfaces of the crankshaft, connecting rods, and bearingsThe engine must be serviced within three hours of recovery to avoid costly repairs Proceed as follows: 1Remove engine cover and rinse powerhead with fresh water2Disconnect the connector between power packs and charge coilDisconnect spark plug leads and remove spark plugs
INote To remove or tWistpull off or push on with slight .Ieads, counterclockwise
3Disconnect fuel line from engineDrain and clean all fuel lines and fuel tankDrain and clean VRO oil reservoirPurge all contaminated oil from supply lines4Place engine in horizontal position (spark plug openings down) and work out all of the water by slowly rotating flywheel approximately 20 times or until there are no signs of water5Drain carburetorsplace engine in upright position and remove carburetors for disassembly and draining6Starters, electrical connectors and all electrical equipment should be completely disassembled, cleaned, flushed with fresh water, treated with water displacing electrical spray, and thoroughly dried before assembly