1990 Johnson Evinrude "ES" Colt/Junior thru 8 Service Manual, P/N 507870, Page 237Get this manual
[1QJ 3 Position spring retainer
CD on pulley as shown
Lubricate spring with OMC Triple -Guard grease or Lubriplate 777Hook end loop of spring to pulley roll pin Install cup and stop assembly with washer over pulleyBe sure spring is positioned through tabs as shown
6Temporarily insert shoulder screw through cup and stop assemblyInstall nut on the shoulder screw to secure assembly7 While pressing down on pulley, turn pulley clockwise and wind spring into cup and stop assembly until outside loop of spring engages outside face of assembly8Slowly release pulley, relieving spring tensionHold starter assembly together and remove shoulder screwsCOAl 78
Position idler gear arm spring idler gear on idler gear arm
in idler gear arm